[ 92.051151][ T808] cfg80211: failed to load regulatory.db qemu-system-x86_64: ahci: PRDT length for NCQ command (0x0) is smaller than the requested size (0x400000) Warning: Permanently added '[localhost]:55765' (ED25519) to the list of known hosts. 2026/10/02 04:19:58 parsed 1 programs 2026/10/02 04:19:58 serving rpc on tcp://37833 [ 104.247526][ T5299] cgroup: Unknown subsys name 'net' [ 104.297376][ T5299] cgroup: Unknown subsys name 'cpuset' [ 104.308267][ T5299] cgroup: Unknown subsys name 'rlimit' [ 125.335137][ T1026] ata1.00: exception Emask 0x0 SAct 0x200000 SErr 0x0 action 0x6 frozen [ 125.335258][ T1026] ata1.00: failed command: WRITE FPDMA QUEUED [ 125.335263][ T1026] ata1.00: cmd 61/00:a8:e6:5f:04/20:00:00:00:00/40 tag 21 ncq dma 4194304 ou [ 125.335263][ T1026] res 40/00:00:00:00:00/00:00:00:00:00/00 Emask 0x4 (timeout) [ 125.335283][ T1026] ata1.00: status: { DRDY } [ 125.335320][ T1026] ata1: hard resetting link [ 125.657444][ T1026] ata1: SATA link up 1.5 Gbps (SStatus 113 SControl 300) [ 125.659002][ T1026] ata1.00: configured for UDMA/100 [ 125.659322][ T1026] ata1: EH complete qemu-system-x86_64: ahci: PRDT length for NCQ command (0x0) is smaller than the requested size (0x400000) [ 125.705343][ T1026] ata1.00: Read log 0x10 page 0x00 failed, Emask 0x1 [ 125.705363][ T1026] ata1: failed to read log page 10h (errno=-5) [ 125.705373][ T1026] ata1.00: NCQ disabled due to excessive errors [ 125.705381][ T1026] ata1.00: exception Emask 0x1 SAct 0x780000 SErr 0x0 action 0x0 [ 125.705393][ T1026] ata1.00: irq_stat 0x41000000 [ 125.705403][ T1026] ata1.00: failed command: WRITE FPDMA QUEUED [ 125.705410][ T1026] ata1.00: cmd 61/00:98:e6:5f:04/20:00:00:00:00/40 tag 19 ncq dma 4194304 ou [ 125.705410][ T1026] res 50/00:00:00:00:00/00:00:00:00:00/00 Emask 0x1 (device error) [ 125.705439][ T1026] ata1.00: status: { DRDY } [ 125.705449][ T1026] ata1.00: failed command: WRITE FPDMA QUEUED [ 125.705455][ T1026] ata1.00: cmd 61/00:a0:36:01:05/20:00:00:00:00/40 tag 20 ncq dma 4194304 ou [ 125.705455][ T1026] res 50/00:00:00:00:00/00:00:00:00:00/00 Emask 0x1 (device error) [ 125.705483][ T1026] ata1.00: status: { DRDY } [ 125.705492][ T1026] ata1.00: failed command: WRITE FPDMA QUEUED [ 125.705498][ T1026] ata1.00: cmd 61/00:a8:36:21:05/20:00:00:00:00/40 tag 21 ncq dma 4194304 ou [ 125.705498][ T1026] res 50/00:00:00:00:00/00:00:00:00:00/00 Emask 0x1 (device error) [ 125.705528][ T1026] ata1.00: status: { DRDY } [ 125.705537][ T1026] ata1.00: failed command: WRITE FPDMA QUEUED [ 125.705543][ T1026] ata1.00: cmd 61/38:b0:36:41:05/07:00:00:00:00/40 tag 22 ncq dma 946176 out [ 125.705543][ T1026] res 50/00:00:00:00:00/00:00:00:00:00/00 Emask 0x1 (device error) [ 125.705570][ T1026] ata1.00: status: { DRDY } [ 125.706535][ T1026] ata1.00: configured for UDMA/100 [ 125.707167][ T1026] ata1: EH complete Setting up swapspace version 1, size = 127995904 bytes [ 127.437892][ T5299] Adding 124996k swap on ./swap-file. Priority:0 extents:1 across:124996k [ 133.505153][ T5314] soft_limit_in_bytes is deprecated and will be removed. Writing any value to this file has no effect. Please report your usecase to linux-mm@kvack.org if you depend on this functionality. [ 135.664932][ T5330] bridge0: port 1(bridge_slave_0) entered blocking state [ 135.665681][ T5330] bridge0: port 1(bridge_slave_0) entered disabled state [ 135.665956][ T5330] bridge_slave_0: entered allmulticast mode [ 135.667617][ T5330] bridge_slave_0: entered promiscuous mode [ 135.685868][ T5330] bridge0: port 2(bridge_slave_1) entered blocking state [ 135.685985][ T5330] bridge0: port 2(bridge_slave_1) entered disabled state [ 135.686269][ T5330] bridge_slave_1: entered allmulticast mode [ 135.687598][ T5330] bridge_slave_1: entered promiscuous mode [ 135.727928][ T5330] bond0: (slave bond_slave_0): Enslaving as an active interface with an up link [ 135.731990][ T5330] bond0: (slave bond_slave_1): Enslaving as an active interface with an up link [ 135.765573][ T5330] team0: Port device team_slave_0 added [ 135.769036][ T5330] team0: Port device team_slave_1 added [ 135.794791][ T5330] batman_adv: batadv0: Adding interface: batadv_slave_0 [ 135.794805][ T5330] batman_adv: batadv0: The MTU of interface batadv_slave_0 is too small (1500) to handle the transport of batman-adv packets. Packets going over this interface will be fragmented on layer2 which could impact the performance. Setting the MTU to 1532 would solve the problem. [ 135.794819][ T5330] batman_adv: batadv0: Not using interface batadv_slave_0 (retrying later): interface not active [ 135.797674][ T5330] batman_adv: batadv0: Adding interface: batadv_slave_1 [ 135.797685][ T5330] batman_adv: batadv0: The MTU of interface batadv_slave_1 is too small (1500) to handle the transport of batman-adv packets. Packets going over this interface will be fragmented on layer2 which could impact the performance. Setting the MTU to 1532 would solve the problem. [ 135.797700][ T5330] batman_adv: batadv0: Not using interface batadv_slave_1 (retrying later): interface not active [ 135.886148][ T5330] hsr_slave_0: entered promiscuous mode [ 135.886989][ T5330] hsr_slave_1: entered promiscuous mode [ 136.151342][ T5330] netdevsim netdevsim0 netdevsim0: renamed from eth0 [ 136.179529][ T5330] 8021q: adding VLAN 0 to HW filter on device netdevsim0 [ 136.181549][ T5330] netdevsim netdevsim0 netdevsim1: renamed from eth1 [ 136.204551][ T5330] 8021q: adding VLAN 0 to HW filter on device netdevsim1 [ 136.206902][ T5330] netdevsim netdevsim0 netdevsim2: renamed from eth2 [ 136.224688][ T5330] 8021q: adding VLAN 0 to HW filter on device netdevsim2 [ 136.226537][ T5330] netdevsim netdevsim0 netdevsim3: renamed from eth3 [ 136.243288][ T5330] 8021q: adding VLAN 0 to HW filter on device netdevsim3 [ 136.312771][ T5330] bridge0: port 2(bridge_slave_1) entered blocking state [ 136.312861][ T5330] bridge0: port 2(bridge_slave_1) entered forwarding state [ 136.313640][ T5330] bridge0: port 1(bridge_slave_0) entered blocking state [ 136.313726][ T5330] bridge0: port 1(bridge_slave_0) entered forwarding state [ 136.392336][ T5330] 8021q: adding VLAN 0 to HW filter on device bond0 [ 136.409436][ T1061] bridge0: port 1(bridge_slave_0) entered disabled state [ 136.410019][ T1061] bridge0: port 2(bridge_slave_1) entered disabled state [ 136.440002][ T5330] 8021q: adding VLAN 0 to HW filter on device team0 [ 136.459552][ T179] bridge0: port 1(bridge_slave_0) entered blocking state [ 136.459665][ T179] bridge0: port 1(bridge_slave_0) entered forwarding state [ 136.478621][ T1061] bridge0: port 2(bridge_slave_1) entered blocking state [ 136.478667][ T1061] bridge0: port 2(bridge_slave_1) entered forwarding state [ 137.143373][ T5330] 8021q: adding VLAN 0 to HW filter on device batadv0 [ 137.210265][ T5330] veth0_vlan: entered promiscuous mode [ 137.222020][ T5330] veth1_vlan: entered promiscuous mode [ 137.265462][ T5330] veth0_macvtap: entered promiscuous mode [ 137.269297][ T5330] veth1_macvtap: entered promiscuous mode [ 137.306632][ T5330] batman_adv: batadv0: Interface activated: batadv_slave_0 [ 137.351509][ T5330] batman_adv: batadv0: Interface activated: batadv_slave_1 [ 137.465926][ T182] netdevsim netdevsim0 netdevsim0: set [1, 0] type 2 family 0 port 6081 - 0 [ 137.468350][ T179] netdevsim netdevsim0 netdevsim1: set [1, 0] type 2 family 0 port 6081 - 0 [ 137.468383][ T179] netdevsim netdevsim0 netdevsim2: set [1, 0] type 2 family 0 port 6081 - 0 [ 137.468404][ T179] netdevsim netdevsim0 netdevsim3: set [1, 0] type 2 family 0 port 6081 - 0 [ 137.782664][ T182] netdevsim netdevsim0 netdevsim3 (unregistering): unset [1, 0] type 2 family 0 port 6081 - 0 [ 138.098562][ T46] Bluetooth: hci0: unexpected cc 0x0c03 length: 249 > 1 [ 138.102347][ T46] Bluetooth: hci0: unexpected cc 0x1003 length: 249 > 9 [ 138.102832][ T46] Bluetooth: hci0: unexpected cc 0x1001 length: 249 > 9 [ 138.119272][ T1329] ieee802154 phy0 wpan0: encryption failed: -22 [ 138.119340][ T1329] ieee802154 phy1 wpan1: encryption failed: -22 [ 138.121888][ T46] Bluetooth: hci0: unexpected cc 0x0c23 length: 249 > 4 [ 138.122164][ T46] Bluetooth: hci0: unexpected cc 0x0c38 length: 249 > 2 [ 138.639822][ T182] netdevsim netdevsim0 netdevsim2 (unregistering): unset [1, 0] type 2 family 0 port 6081 - 0 [ 139.457373][ T182] netdevsim netdevsim0 netdevsim1 (unregistering): unset [1, 0] type 2 family 0 port 6081 - 0 qemu-system-x86_64: hw/ide/core.c:925: ide_dma_cb: Assertion `prep_size >= 0 && prep_size <= n * 512' failed. Connection to localhost closed by remote host.